Unitary products group DNH018 Bedienungsanleitung PDF herunterladen

GENERAL

This filter and frame kit may be used for horizontal or vertical

air flow and with or without an economizer.

INSPECTION

The following list details the parts included in this kit. Inspect

the kit to ensure that all listed parts are included.

CONTENTS OF KIT

TOOLS REQUIRED FOR INSTALLATION

A hex nut driver

⁄

" is the only tool needed to install this kit.

This tool is not supplied with this kit and must be supplied at

time of installation.

INSTALLATION

Install the filter and frame kit as follows:

1. Remove the 5 screws on the blower access panel and

remove the panel.

2. Assemble the filter bracket to the bottom filter rack with two

#10 screws.

3. For horizontal airflow applications, remove the two (2)

screws from the bottom duct cover closest to the blower.

For vertical airflow applications, the bottom duct cover will

be removed and installed over the horizontal duct opening

on the outside of the duct panel.

4. Place the filter bracket and bottom filter rack assembly into

the unit and attach to the bottom duct flange with two (2)

#10 screws.

5. Remove the left screw on the front heat exchanger plenum

and the left screw on the back of the heat exchanger

plenum.

6. Insert the tab on the upper filter rack into the notch in the

filter bracket. Secure to the heat exchanger plenum with the

screws removed in Step 5.

7. If the 1 inch filter will be used, install the angle bracket to

the upper and bottom filter racks to act as spacers. If these

brackets are not installed, the filter may rattle during opera-

tion. If the 2 inch filter will be used, the angle brackets are

not needed.

8. Slide the filter into place and replace the blower access

panel.

FOR SINGLE PACKAGE AIR CONDITIONERS

1.5 THRU 3.5 TON

035-13208

Subject to change without notice. Printed in U.S.A.

530.46-N1.18V

745 Industrial

Parkway

West

Elyria

44035

Unitary

Products

Group

ITEM QTY. DESCRIPTION

1 1 Upper Filter Rack

2 1 Bottom Filter Rack

3 1 Filter Bracket

4 2 Angle Bracket

5 1 High Velocity Permanent Filter, 1"

6 8 Hex Head Screw, #10 x

⁄

INSTALLATION

INSTRUCTION

Supersedes: Nothing 530.46-N1.18V (995)

FILTER / FRAME KIT

MODEL 1FF0110

FIGURE 1 - FILTER / FRAME KIT ASSEMBLY

INSTALLATION 1
INSTRUCTION 1

Inhaltsverzeichnis

Seite 1 - INSTRUCTION

GENERALThis filter and frame kit may be used for horizontal or verticalair flow and with or without an economizer.INSPECTIONThe following list details

Kommentare zu diesen Handbüchern

Keine Kommentare

Unitary products group DNH018 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Split-System-Klimaanlagen Unitary products group DNH018 herunter. Installation - Filter/Frame Kit [en] Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern